I've done it both ways, but honestly it's actually easier to simply draw the "ground splash" (GS) as the last [Emitter.n] section in the .fx file. Obviously, the same technique will apply to nav lights as well as the beacon. By having two versions of the same .fx file (one with GS and the other without) means you have an easier time with on/off ground control!
Here's the GS entry for the strobeGS.fx file. Note the [Particle.n] entries in red below.
The X Scale= and Y Scale= entries define the diameter of the GS.
The Ground Normal=1 entry "flattens the effect to be parallel to the ground"
The Y Offset= entry is set to offset the "GS" to be just barely above the ground. This needs to be just high enough that it won't sink into the ground when the a/c is fully loaded to the max pax and fuel!![]()
If I put it in a .fx file. The groundsplash doesn´t stay on the ground and is also vicible in the air. What did i do wrong?




