• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX Apron was missing

chewbacca

chewbacca

Messages
16
Country
indonesia
Hi everyone,

I have problem with my apron model created using gmax. Taxiway, marking, runway and overlay was fine and showed nicely, but not the apron.

It appears when I zoom it out from top view
showf.jpg


And it's gone if I zoom in
gone.jpg


I've flatten the area using sbuilderx. I'm using 6 layer and tweaking the asm from 8 until 32. Apron was placed in 3rd layer. Everything was fine except the apron layer. Anyone knows why?



-Nanda
 
Last edited:
apron

Hi,

Try raising the apron slightly up in gmax. Or all the layers.
Is this your top or bottom layer?

I not sure if this is your problem!

DG
 
Hi,

Raising it should not matter.

You could try to use lower layer numbers, most people start at layer 0 or 4 (and then increment by 4).

I assume it only happens in the top down view? Or does the problem also happen in normal views?
 
It was also occurred from spot view. Thank you guys, finally I solved it. There was something wrong with my model. I've re-created the ramp, and now it works. Thank you again!

Have a good day

-Nanda
 
You must log in or register to reply here.
Back
Top