• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Cockpit finalized...

K

kdryan

Messages
361
Country
us-indiana
That's it for the Mystery Ship Cockpit. I am through trying to make it more accurate and am calling it final. While I'm sure Herb Rawden and Walter Burnham would recognize it, I am equally sure there are spots they would say 'What the hell is that?' :) My question is, now having put the work into this, so it looks good from the outside, can any of this be used for the VC?

So, I finish tweaking the fuselage and I'm done. If my monitor hadn't died, I would be finished by now.

Kevin

cockpitfinal.jpg


cockpitfinal3.jpg
 
Last edited:
Of course...

In fact, create a single polygon (face down so it will be invisible) and name it "exterior" (without the quotes of course)...

Link all the exterior part top level parts to the exterior node.

Select everything, Clone, and then name the cloned exterior1 node to "interior" (again, w/o quotes)

Now you have the parts for your interior (vc) model, and can continue whacking away.

Hint: do NOT bother to do this until you've UVW Mapped and textured the entire exterior model so you won't have to chew the same bit of cabbage again... :rotfl:
 
You must log in or register to reply here.
Back
Top