• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Crash FS9 after using CAT

carlos_fernandes

carlos_fernandes

Messages
10
Country
brazil
After making the condition as the FS crash tutorial on using. Mdl generated by cat
Steps followed.
Window 1
Enable Anim enabled
Condition (between)
NAV2
Min 1200h Max 1200h

Apply to trigger Animation

Window 2
Enable Animaiton Trigger enabled
Variable - NAV2
Min 1200h Max 1200h

Window 3
No change.

Without the change with the CAT the animation usually happens.

I remember I made this same procedure a few months ago and managed to make the animation, but direct the animation, occurring jump to the starting position, as shown in aid of CAT.
 
Hi,

I am not sure I understand your question completely, does FS really crash when you use the tweaked MDL file?

One problem could be that you used the same variable for the trigger and the animation condition. That is not how it is supposed to be, it sounds like you can just as well use it for the trigger only.

Also always make sure to test your animation before using CAT, so that you know that the original animation has no problems left.
 
Problem solved.
But I have another question now.
My gate has 3 Animation .... how can now ... tried everything following the tutorial and not succeeded.

Applying the second condition I have no animation.
I am attaching the file .max I am grateful if you can help.

For Animation 1 is to connect on Airbus
For Animation 2.3 for Boeing

Sorry for the English, I am using a translator
 

Attachments

You must log in or register to reply here.
Back
Top