• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Creating a sandbar on a redrawn river

D

dominique

Messages
23
Country
france
Hi everybody

Newbie with ADE here but a simmer for 35 years. The last time I made sceneries was with Terrascene in Fly! so I may be a little rusty in this department :) ! I've been using ADE for a month now and I'm very impressed by its friendliness to the user and ability to help you to get the job done !

I found solutions to the numerous issues I encountered, in the manual or on this site, while doing an extensive revamp of an airfield in OrbX OpenLC EU. One still perplexes me.

I've redrawn a river, first adding to the existing river two tiny "Exclude General/Water Polys" polygons in the upper and lower segments, then drawing a water polygon for the river with River Perennial.

Now I want to draw a sandbar in the middle of the river mouth. I add on top of the river polygon an Exclude Specific Hydro Polygons Generic River Perennial poly shaped as the sand bar and on top of it a clone with a sand landclass. Nothing shows up but the river polygon !

Thanks for any clue

PS how do you add the prefix of your sim to the tile of the message (P3Dv2 for me) ?
 
Last edited:
You must log in or register to reply here.
Back
Top