I've been trying to figure out painless ways to do ground markings for ages. The colored_marking tile has been tormenting me for ages as it was always mirrored.
I turns out if you set it as a polygon surface you can fold the polygon in on itself and it reverses to the correct way around, or it may start off correct.
However the text is much smaller than the apron version and it's proving impossible to trim to individual letters. For some reason moving one point of the polygon, all the others stay fixed, causes the tile to scroll until your target is gone again.
Am I missing an obvious trick here or is this simply a fluke it's not really designed for?
I turns out if you set it as a polygon surface you can fold the polygon in on itself and it reverses to the correct way around, or it may start off correct.
However the text is much smaller than the apron version and it's proving impossible to trim to individual letters. For some reason moving one point of the polygon, all the others stay fixed, causes the tile to scroll until your target is gone again.
Am I missing an obvious trick here or is this simply a fluke it's not really designed for?