• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 FS9 Clouds + DXT3 texture

Messages
383
Country
unitedkingdom
Hi

Just wonder if anyone has come across or found a work around for the following issue.

I've build an localizer array which has wires strug between each upright pole. The texture for the wire uses an alpha channel which at first I used pure black to remove the area inbetween the wires, in FS9 they shimmer and role really bad when moving around. To reduce this I made the area in between each wire 90% transparent and converted the texture to DXT3. This makes the texture look much better and the rolling effect has gone, however the clouds when looking through the texture do not show through, a couple do but the majority dont.

I have come across this before when making fences, etc but it has not been a problem due to the fence being to low for the sky to become an issue.

DXT3 texture with the area in between made 90% transparent, majority of clouds dont show through
Array5.jpg


DXT1 texture with area in between wires pure black
Array6.jpg


Obviously the wires in the second screenshot will be ok if there is no work around, but I'd rather they had the smooth lines in the first screenshot (but with clouds) than the jagged lines of the second screenshot. The texture is 1024 x 1024

I'm looking for a way to use DXT3 wit hthe 90% transparent areas and have the clouds show through.

Thanks for any pointers

Stevo ;)

P.S I've also tried 8bit, 16bit 444 and 32bit all have the same effect.
 
Last edited:
Back
Top