• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Help with taxiway joining r/w

icon 22

icon 22

Messages
10
Country
us-idaho
Well, I'm baaaaaack!

This time I'm trying to add a taxiway to a runway at KSZT. All goes well except the taxiway edge lines protrude half way onto the runway. (see attached)I have tried both 90 degrees and at an angle with no luck. I have also been following Mac's thread with interest. Also the taxiway edge lines on the fillet don't match up with the straight taxiway lines.

BTW, I just love this program. Thanks to Scruffyduck & all!

Any help would be appreciated.


KSZT.jpg
 
Hi Gary
I've just made the same connection to rwy 19 and it showed up perfectly
your pic looks like the taxiway is not connected to the black rwy line, can you hover your mouse over the the blue node ON the rwy where you have connected your taxiway to the rwy, and see if you get all three lines highlighted that come from this node

Ray
 
Hi Ray,

Thanks for the reply. That was it! Rookie mistake, but I'm learning! Now back to creating. :)
 
Gary
Thats good,the pic was a great help,
the fault finder should also pick that up,
it will come up as an orphan node
happy creating :)

Ray
 
You must log in or register to reply here.
Back
Top