• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

P3D v4 Library Object shows it's bright, white, border during nightime

Messages
62
Country
unitedkingdom
Hello,

I'm having an issue with a Library Object named: "lightpost_object_smallwash".

Whenever it's nighttime, you can see the white square border of the object as shown below:
1611513960150.png

Any suggestions on how to remove the white square?

Many thanks.
 

tgibson

Resource contributor
Messages
11,327
Country
us-california
There is supposed to be a partially transparent texture on that polygon. You appear to be missing the texture. If you can't find it, you could always place the object a little below the ground.
 
Messages
62
Country
unitedkingdom
There is supposed to be a partially transparent texture on that polygon. You appear to be missing the texture. If you can't find it, you could always place the object a little below the ground.
Placing it below the ground solved the problem for me but I'll need to have a closer look with that missing texture. Thanks for the suggestion!
 

tgibson

Resource contributor
Messages
11,327
Country
us-california
If you load the object into ModelConverterX and look in the Material Editor, it should specify which textures are needed by the object. The cross hatched ones are missing.
 
Top