• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Makemdl 2002

Hi,

That is not possible. MakeMDL always rounds the value of the heading. You could only do this by editing the ASM source code manually, but the heading is stored in not so easy to read hexadecimal values. So it is probably best to rotate the object in the program you created it in.
 
Hi,

That is not possible. MakeMDL always rounds the value of the heading. You could only do this by editing the ASM source code manually, but the heading is stored in not so easy to read hexadecimal values. So it is probably best to rotate the object in the program you created it in.

Thanks Arno. can you give me the lines wich i should change for the heading in the .asm? thanks Arno
 
Hi,

It's the SCALE_AGL command. The heading is stored in the last two parameters. I think there should be a thread on the forum as well that explains how to decode the hex values.
 
Sorry for my ignorance, but I have a problem. I have rotated my model in gmax, but when I put the model to the simulator is located at 0 º. I exported the model with the gmax makemdl 2004 and then move the .x file to makemdl 2002, you can help me? I need rotate my runway at 124.08 degrees but i can't.
thanks for all
 
Thanks! i changed this line

INSTANCE_CALL OBJECT_0_BEGIN, 0, 0, 0582dh

For this

INSTANCE_CALL OBJECT_0_BEGIN, 0, 0, 0583ch
and my runway is aliggned! thanks Arno for your comments!
 
Back
Top