• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

mission runs but no speach output

A

AFTRS

Messages
180
Country
spain
Hi,
IMM developed Mission. Then store mission inside the flight within FSX.
Load stored mission flight within orig. FSX Mission dialog.
Afterwards all the "Say....." s in any progression steps are ignored.
The indicated POIs and so on keep on running. So mission keeps in progress
Just the speach is gone.
Any Ideas to solve this?
Christian
 
Seems to be the "none" option in the say "".
I did change the xml manually and there it went.
Thought that one was sorted out with 1.04 of IMM.

Never the less: I like that FSX mission engine.
You can correct that many errors within the native FSX installation, involve that a mass of events, take care of that a lot of things:
Unlimited possibilities.

And it now works with the P3D-software :-))
 
You must log in or register to reply here.
Back
Top