• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Plane Interior LOD Problem in MSFS 2024

N

Negotiator

Messages
13
Country
ukraine
have noticed that when I go to outside view on some planes, the interior is missing unless I zoom in real close. It seems to be an LOD problem, as I can go into Developer mode and force the LOD to 0 and the interior pops up.

In third party planes, like the 337, the interior is completely missing, in a default plane from 2020 (like the DA40 improvement mod), the interior is visible, but only at a low LOD level. Again, you have to zoom in to be next to the plane before the LOD doesn't reduce quality.

If this is an LOD reduction for better performance with 2024, it is much too aggressive, as going into external view should not knock out the interior of the plane completely!

This just started happening to me after the latest update that was pushed out. Anybody else having this issue? Is there something in my settings I need to be looking at?

Having to go into Developer mode and force the LOD to 0 is not a workable solution.
 
You must log in or register to reply here.
Back
Top