• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 problem with carrier elevation

muffo

muffo

Messages
353
Country
italy
Hi I put carrier near Elba island and I created an airport on it, but I have problem with elevation airport, that I changed but the result is the same ( I created flaten too). My airplane is on sea elevation and the carrier is above this is the photo with my files....solution ?
 

Attachments

  • elba_24012014_092835.jpg
    elba_24012014_092835.jpg
    80.8 KB · Views: 495
  • ELBA.ZIP
    ELBA.ZIP
    43 KB · Views: 194
Hi,

You do not need a flatten as the apron at the altitude of the flight deck is enough to harden the surface.
On the other hand, you need another so called ocean flatten airport at sea level that consists of only an apron link wide enough to cover the surface of the carrier to prevent the water from rising up. This extra airport has to be put in a higher UP layer in the scenery library LIST than your carrier airport.
There are some examples of how to do it if you search for instance for "carrier".
 
You must log in or register to reply here.
Back
Top