• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Rotated Part

Messages
106
Country
germany
Hi Guys,

i have a rotated part with keframes 0-100 (see picture).
I wish that this part is not at "0" when it is loaded. It should begin with "50".
how i must write the code.

the part must start in the middle at "50" and rotate left or right with the mouse wheel.

code modeldef
Code:
<PartInfo>
	<Name>sx16_lr</Name>
	<AnimLength>100</AnimLength>
	<Animation>
		<Parameter>
			<Code>50 (L:lr_sx16,percent) 100 *</Code>
		</Parameter>
	</Animation>
</PartInfo>

code gauge
Code:
<Area Left="166" Top="123" Width="21" Height="22">
<Tooltip>LEFT SX-16</Tooltip>
<Cursor Type="DownArrow"/>
        <Click Repeat="Yes">
             (L:lr_sx16, percent) 0 &gt; if{ (L:lr_sx16, percent) -- (>L:lr_sx16, percent) }
        </Click>
</Area>

<Area Left="202" Top="140" Width="21" Height="22">
<Tooltip>RIGHT SX-16</Tooltip>
<Cursor Type="UpArrow"/>
        <Click Repeat="Yes">
             (L:lr_sx16, percent) 100 &lt; if{ (L:lr_sx16, percent) ++ (>L:lr_sx16, percent) }
        </Click>
</Area>

example-picture

rotated_part.jpg


Mijo
 
There are two possibilities:

-If (L:lr_sx16,percent) is a variable which its single purpose is to control the part's rotation, you can write:

in modeldef
<Code>(L:lr_sx16,percent) 50 + </Code>

in gauge
(L:lr_sx16, percent) -- -50 max (>L:lr_sx16, percent)
(L:lr_sx16, percent) ++ 50 min (>L:lr_sx16, percent)


-If (L:lr_sx16,percent) is a standard percent variable that you need to init at 50%, then you can write:

in modeldef
<Code>(L:lr_sx16Init) ! if{ 50 (>L:lr_sx16,percent) 1 (>L:lr_sx16Init) } (L:lr_sx16,percent)</Code>

in gauge
(L:lr_sx16, percent) -- 0 max (>L:lr_sx16, percent)
(L:lr_sx16, percent) ++ 100 min (>L:lr_sx16, percent)


Tom
 
Back
Top