• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Studio Max Outer Edge Loop Trick

Zeiten

Resource contributor
Messages
444
Country
norway
Hi.

Sorry for the title, but could not find a more suitable title :D

If you have an cylinder e.g you cannot loop one of the "edge edges" so to speak.
You can only loop one of the middle on.
Found a cool little trick to overcome that.
Well, a picture says a thousand words..

EdgeMode.jpg
 
Interesting!


Working in Gmax, I found that in a side view, I can select that entire area with selection, then hold down the ALT key and deselect the area behind the edge or row and then all the edges of that thin area are selected.

I used to click on every single Edge at a time, taking like 3 long massive min's.

There was a Script that worked on selecting edges and rings, but I could never get it to work.

Congrats on the find! That will really help you with speed.


Bill.
 
Forgot to tell that this also can work the other way around.

You can not e.g loop polys, but then again you can loop the edges around a cylinder and the hold down the CTRL key while going back into poly mode to highlight all the polys.

Some times this works faster then entering side, front, top etc view to select all polys and "ALT" off the ones you not need.
 
Another workflow

Select all the "other" polys.

Then invert selection.
 
Back
Top