• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Texturing not so good...

Messages
75
Country
us-southcarolina
I am looking for an opinion or guidance. I am new to creating 3d models and texturing. I created a hangar model and textured it via a texture sheet. The screen capture below is my latest hangar. But I am not satisfied with the way the hangar looks. The graphics are to blurred. I would like a little more detail. I am not a graphics expert, but to get a little more clarity in my textures, what do I need to change? For this hangar I used a 1024 x 1024 texture sheet. For the side that you can see, it was 1024 x whatever the system gave it to keep perspective. I think it was also 72dpi, same as my texture sheet. Can someone give me a quick graphics 101 to help me with texture clarity/resolution? I do know for these things, you probably do not want high def, but I am unsure on how to tweak for greater resolution. Thanks, Robert

upload_2015-9-29_14-41-29.png
 
DPI is a printer setting and has no impact on FS.

How long is that hangar?

1024/length of building = pixels per unit of measure.

For hangars like that I like to use 10 pixels per foot, so I can get 102.4 feet of continuous building width on a texture sheet. Actually a bit less as you don't want to map right up to the edge of the texture sheet.

You could cut the side of the building in half, if it is all one poly, and increase the texture resolution. Then map both halves of the wall to the same part of the texture.

cheers,
Lane
 
Ahhhhhh...thank you Lane. This hangar is 310' long, so that probably explains it. After I add the texture, I grab a screenshot of the entire side to create my texture sheet. So, if I understand you correctly, I should probably grab only the one section (this is a 7 section/side T-Hangar so a section would be the width of the door) , then texture one section at a time across the entire length of the building?
 
Yeah, you could make one section like this...

Capture.JPG


and repeat it down the side of the building. That way you could have a much higher pixel/foot ratio and make it look a lot sharper.

Right now you are at about 3 pixels/ft. If that section of wall is say 40' long, you could paint it on a section of your texture sheet 400 pixels long and get 10 pixels/ft.

The downside of doing it this way is all sections will look identical. You might consider making two or three different sections so you can mix them up a bit. Or have them all the same, your choice.

cheers,
Lane
 
Back
Top