Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.
By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

No, go back to the earlier save but plan to map once the object is complete.


Well... I use Boolean quite a bit where I need it: others use Cut and Slice because they hate Booleans or can't get on with them. Cut and Slice won't bork an existing mapping so some cut out doors etc after mapping and don't have to map the doors separately. I use Boolean to do these cuts and either map doors together with a fuselage or detach the resulting door polys after mapping the lot as one object.
There is always more than one way to swing a cat, and neither method is wrong. Now that I use Max there's always ProBoolean...



I'm usually using Reference in a Boolean with the operation Cut and Refine.



I find booleans quite handy.![]()

Booleans are a total PITA in any modeling program...I find booleans quite handy.![]()
But I still use them... That is before mapping.