• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX ai helicopter behaving erratically after take off

C

Chris75

Messages
17
Country
unitedkingdom
Hi There

I have an ai helicopter S61n with a repaint in BHL colours an old chopper I used to work with G-AZDC.

the problem is its wheels are fixed in the ground and on taxi-ing its whole front end plows into the ground (I have managed to correct this see below) but now the rotor blades do not turn and after take off it climbs up to the correct altitude then at about 2 miles out the aircraft begins to yoyo up/down by about 1000 feet then turns on its side and plummets into the sea.

Can anyone explain what is going on? where can I fix this and how. I believe it may be the aircraft cfg file, it was based on an old cessna so I modified it using a cfg file from a non ai s61n. this did help certain charecteristics i.e. the wheels and front cabin in the ground, to behave.

Thanks in advance
I am unable to attach the cfg and air file at this time as when I try to using the attach files button they do not show up in the explorer window that opens.
 
Just found out it is an FS2002 aircraft, though it does show in fsx but as I said above behavour is not good.
 
You must log in or register to reply here.
Back
Top