• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Airport scenery BGL

B

Butch1

Messages
228
Country
unitedstates
In a P3D scenery, the bgl that should show all the runways etc only shows a red circle with a red T. Oakland (KOAK).

I've looked at all the other bgls and none of them will not open with ADE. So why is there no runways showing?
This is a aOAK.bgl and below it is aOAK_CVX.bgl


Capture4.JPG
 
Your screenshots are very hard to see but it seems that you have the zoom factor for the display set very far out. CVX files cannot be loaded into the ADE display.

Please post the two bgl files you refer to above so I can take a proper look
 
There are no runways showing since there are none in the bgl file. There may be runways at the airport but they are not stored in the bgl file. It contains a few bits

1676473990797.png


The CVX bgl file contains terrain data which ADE does not read.

The stock airport contains all the runways and other elements

1676474128201.png



My only guess is that whoever created the bgl file did not want the airport facilities in it or put them in a separate bgl file stored alongside the on you have.

The obvious question is where did you get the bgl file(s) from?
 
You must log in or register to reply here.
Back
Top