• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX Annotator Problem

Messages
454
Country
wales
Sorry to be a pain guys but I have run up against a problem with my Autogen Annotator.

Everything was fine yesterday.

When I ran the annotator this morning the Config Editor went into full screen mode and I can see no way in which to reduce it or minimise it.

Also the little box that has the Vegetation groupings does not appear.

Have I pressed something by mistake that I shouldn't have done.

I have removed the FSX SDK from Add/Remove and reinstalled it. I downloaded the version SP1a that replaces the original. I have also removed and reinstalled the Acceleration SDK but the problem remains.

The only other thing I did this morning and I can't for one minute think that it has any bearing on it and that is downloading and running BGL2XML from Jon's site.

Help!!!!!

OK I have just read that you can only reduce the size of the config editor and not actually minimise it.

But I still do not see my vegetation grouping box.


Regards

Richard
 
OK guys I have resolved this problem.

Found the answer and that is to go to the config editor/view/windows and there was a selection vegetation groupings.

I clicked on that and hey presto.
 
Back
Top