- Messages
- 10,163
- Country

Hey all,
I was just mapping an engine with some 'tiled' graphics, and basically they will all have the same mapping Plannar, a cube at 1X1X1 size Plannar. Just out of curiosity, I right clicked on the UVW line in the RH control box (stack of the object) and found I could copy it. I then clicked on the next object that has the same material and would have the same UVW Plannar and sure enough, it pastes, and the coordinates/sizes are identical.
Wanted to share that with you all. I never knew this was possible....
Bill
I was just mapping an engine with some 'tiled' graphics, and basically they will all have the same mapping Plannar, a cube at 1X1X1 size Plannar. Just out of curiosity, I right clicked on the UVW line in the RH control box (stack of the object) and found I could copy it. I then clicked on the next object that has the same material and would have the same UVW Plannar and sure enough, it pastes, and the coordinates/sizes are identical.
Wanted to share that with you all. I never knew this was possible....
Bill



