- Messages
- 235
- Country

I have a post from 2011 that deals with cable animation, but the pictures that would have been in the post are no monger there.
I am looking to animate a pulley and cable system that would control a boom to lower the small watercraft from the roof of the yacht.
Here is what it looks like:
I know it has something to do with creating a skinned mesh for each section of wire with "bones" at each end, linked to the pulley.
The Gmax tutorials was not very helpful in explaining haw to create the "skin mesh"
I tried this morning to start with a "cylinder and tried applying the "skin" modifier, but it was giving me a registry error. Although it did show the skin modifier in the stack, at witch point I could add bones.
The questions I have are the following:
1) How do I create the skin mesh?
2) Is the mesh created first, then the bones added?
3) does the "bone" have to be centered on the wire or can it be offset, to be located on the center of the pulley, while the cable is on the edge of the pulley?
Michel E Paquette
I am looking to animate a pulley and cable system that would control a boom to lower the small watercraft from the roof of the yacht.
Here is what it looks like:
I know it has something to do with creating a skinned mesh for each section of wire with "bones" at each end, linked to the pulley.
The Gmax tutorials was not very helpful in explaining haw to create the "skin mesh"
I tried this morning to start with a "cylinder and tried applying the "skin" modifier, but it was giving me a registry error. Although it did show the skin modifier in the stack, at witch point I could add bones.
The questions I have are the following:
1) How do I create the skin mesh?
2) Is the mesh created first, then the bones added?
3) does the "bone" have to be centered on the wire or can it be offset, to be located on the center of the pulley, while the cable is on the edge of the pulley?
Michel E Paquette



