• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

P3D v5 Can't change tower height

V

vortex471

Messages
3
Country
unitedkingdom
For years I've been making helicopter training fields with a tower view point at ground level. It's been no problem for years but for some reason since going to v4.5 and then v5 the tower view point is always around 100ft above the ground and no matter what value I enter it is always that high. I have tried 0 feet, 0.1, 0.5. 5 etc and the view point still is straight above the aircraft.
I was hoping someone had the same problem and there was a work around but searching the forum nobody has seemed to have the issue?

Versions:
Application 01.79.7475.29407
Engine 04.75.7475.29405
 
You must log in or register to reply here.
Back
Top