• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Crosswind runways

E

efpg0708

Messages
25
Country
brazil
Hello. I´m trying to set up some crosswind runways in SBVT in P3D, and I´m not sure if I´m doing it right.

The runways are 02-20 and 06-24. When the winds are coming from the south/southwest, runway 20 is used for takeoff and 24 for landing. So I set up the crosswind runways as it follows: https://www.img91.com/en/l5QhayAJsvHPfcO

As for the patterns settings, I did the following:

Runway 06 - CLOSED for both takeoff and landing

Runway 24 - CLOSED for takeoff and OPEN for landing

Runway 02 - CLOSED for both takeoff and landing

Runway 20 - OPEN for takeoff and CLOSED for landing

However, when I fire up P3D, traffic still lands on runway 20, which is closed for landing. When requesting to land using the ATC window, I can select both 20 and 24. Is that supposed to happen ? How do I prevent traffic from landing on runway 20 ?

Thank you

Eduardo
 
You must log in or register to reply here.
Back
Top