• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSXA Elevator trim indicator

euroastar350

Resource contributor
Messages
863
Country
us-delaware
Hi guys,

What is the proper way to animate a trim indicator and what is the variable that controls it's animation? Assuming it's
Code:
(A:ELEVATOR TRIM INDICATOR, position)

The BN2A MKIII Trislander project is close to almost being finished with some smaller items left to be done, so it's a matter of adding the smaller missing bits observed by one of my testers. Any help is appreciated
BN_Trim.jpg
 
I like to use (L: ELEVATOR TRIM PCT, Percent)
animation start from KF 30 to 80
KF = 50 is zero trim,
think you need to make reset script for that (can be done in xml).
i.e if each value ( -1, -2, etc) as decrease by 5 value, trim will reset to 30% if trim less than 30%, and vice versa for value +8


 
I think I animated all of mine with 0 thru 100 and 50 was center. Just have to animate it and put it in the sim and see if it goes the right way. If not, just flip it and re-export it and recheck in the sim.

Getting the elevator trim wheels to work right was always my problem.
 
I like to keep it easy when I can. I use the stock "trimtab_elevator_key_pct" animation. 0=full down, 50=neutral, and 100=full up. Works well for me on an indicator that is similar to yours.
 
Back
Top