Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.
By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.




It requires SimConnect and C++....
I'm not sure you get misfires with carb icing, all the accident reports I've read where it's been a factor seem to indicate it's quite a subtle fault as the engine appeared to be working normally but wasn't producing enough power to clear that hedge/barn/wire etc. Similarly I've had it in an R-22 a couple of times where applying carb heat gave an noticeable improvement in engine output but there was no real indication beforehand that anything was wrong.

Thats the only way to do it? You would think there was an easier way.



"Carb ice can cause, although rare, a misfire," agree, it just might happen but surely a"one of a kind" event in one out of thousands....hummm,. I still have to see FSX figuring out how to simulate ice problems.....X-Plane does it well. There is some software somewhere advertising "ice situations even on the ground for FSX" but their previous products are really not anything to brag about.