• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Excluding FSX-Autogen trees...

DanKH

DanKH

Messages
221
Country
denmark
Hi

I made myself a nice small apron at a couple of airports, but the trees grows up through the concrete...

I made an ExcludeRectangle with the SDE, but that didn't seem to remove the trees.....

Any better way to to it?

Btw. FXplanner, ADE and SDE is three wonderful programs to use in conjunction.... I always use the latest version, and I must say that improvements grows quick on all. Pretty good job all.....

Did any of you consider showing the angle/distance between two points drawn? That would be a nice utility especially while drawing aprons, fences, taxiways etc.

Thank you in advance.
 
Well, the best way is to try it for yourself obviously....

SbuilderX did the trick:

Slewing around to each corner of the apron while connected in Sbuilder to define the polygon, and then set the properties to Airport_Backgrounds_ExcludeAutogen ..and voila all the trees vanished.

Case closed.
 
Yes Dan, using the mesh "polygons" to create the exclude is indeed the best choice. And SBuilderX is a nice tool to draw them.
 
You must log in or register to reply here.
Back
Top