• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX Export Failure

S

Southwest

Messages
1,101
Country
unitedkingdom
Hi All,

I attempted to export my model as done so far into FSX SP2 to check the progress, i had reset the scale and transform aswell as setting a GUID, on Export i got this message;

123-1.jpg


Any idea what it mean's please ?

Kind regards.
 
I really don't know. That error message usually comes up when I'm modeling...
Try to merge the model into a new scene and try again... O see if you have any parts with "edit mesh" modifier, at least with me it solved the problem for that same scene...
 
The error message is reporting a program crash of the export module due to invalid and/or conflicting data in a bitarray (probably a buffer overrun).

To find the offending part in your scene, begin a sorting process that will narrow down the possibilities.

1. Select 1/2 of the parts and run Export Selected.

2. If export succeeds, "Hide" that 1/2 of the parts, Select the remaining 1/2 and repeat step #1.

3. If export fails, "Invert" your Selection and "Hide" them, then repeat step #1.

By using this divide-and-conquer technique, eventually you will locate the offending part(s). Once identified, then we can investigate why they are failing to export successfully.
 
Thanks for the response's guys. I did as Bill suggested and the issue is a single window that can be remade in a few seconds. Thanks again, really appreciate it !
 
You must log in or register to reply here.
Back
Top