Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.
By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Thank you. If I make the fuselage panel lines harder it is more noticeableLooks like a quality model for low poly. Very nice work in my opinion.![]()
I am using AC3D, GMAX, MCX, Arnos fx editor, Air Wrench, Fs Panel Studio, Photoshop and Illustrator. The mesh was born in AC3D and moved to GMAX. I also use the FSX acc and P3D 3.4 SDK + Notepad++Looks nice, which tools are you using to create this model?
Thank you!I am using AC3D, GMAX, MCX, Arnos fx editor, Air Wrench, Fs Panel Studio, Photoshop and Illustrator. The mesh was born in AC3D and moved to GMAX. I also use the FSX acc and P3D 3.4 SDK + Notepad++

That's interesting using AutoCad. What is your process converting files from AC to your final export to X?I am using AC3D, GMAX, MCX, Arnos fx editor, Air Wrench, Fs Panel Studio, Photoshop and Illustrator. The mesh was born in AC3D and moved to GMAX. I also use the FSX acc and P3D 3.4 SDK + Notepad++
Rotorhub
Sorry for the confusion. AC3D is a low price 3D software that I use to make X-Plane models. It is easy to use, but it does not support FSX, and it does not support animations. But it can save DirectX files that converts very nicely in ModelconverterX. I really wish that AC3D had animation support, it would be a good alternative to the unsupported GMAX, and the expensive 3DS Max.That's interesting using AutoCad. What is your process converting files from AC to your final export to X?

That's interesting using AutoCad. What is your process converting files from AC to your final export to X?


I did look it up, can't put much of an opinion on it. It seems rather limited. Blender would be a better choice if cost is a factor.