• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

P3D v3 Flattern Issue_SbuilderX 3.14

Jack737Fly

Jack737Fly

Messages
12
Country
italy
Hello guys,

I am try to flattern my photoreal terrain using SbuilderX. But every time i got this problem(see picture in the attchament).

Any advice please?

Thanks in advance!

Cheers,

Giacomo
 

Attachments

  • 2016-8-6_15-8-8-286.jpg
    2016-8-6_15-8-8-286.jpg
    447 KB · Views: 399
  • 2016-8-6_15-8-36-282.jpg
    2016-8-6_15-8-36-282.jpg
    730.6 KB · Views: 367
Your airport is not at the same elevation as your flatten. Your flatten has the wrong altitude.
Either you have to set the flatten to the same altitude of the airport or you have to match the airport altitude to the flatten.
You gave too little information to pinpoint the problem.
What tool do you use to make the airport? Is it the default airport? What kind of flatten did you put in? Did you take out the default flatten, etc.?
 
The airport in question is not a default, it does't exist, I created it all my self using ADE and Sbuilder. With Sbuilder I used AB_Flattern(I think is a default flattern). Currently with the airport I'm using Orbx(global, vector and EuropeLC).


In the attchaments below there are all Flattern settings that I have. Which do u suggest to use?

Thanks!


Giacomo
 

Attachments

  • flattern settings.PNG
    flattern settings.PNG
    646.5 KB · Views: 619
Hi !

In your picture you don't show the Flatten settings , there are in the "General" folder.

As said Roby , the airport is not at the same altitude as the Flatten .

You can modify your Flatten altitude in the "general" folder of SbuilderX , and you can modify your Airport altitude in ADE , Tool menu and change airport altitude .

show_image
 
You must log in or register to reply here.
Back
Top