Hi Ed:
I just got a few more minutes free during a break from driving at a Starbucks to leech off their Wi-Fi with this (ridiculous) I-Pad2
non-computer.

.
A few comments:
AFAIK, In Sketchup, we rarely need to concern ourselves with what orientation our "Normals" are pointed in, as this aspect of our 3D models is handled automatically and MCX imports / exports our models with little if any need for modification by us as end users.
It would be desirable to do the extra step of disabling export of "2-Sided Faces", wherever possible, since it results in there being less vertices in our 3D models as IIUC, textures add an extra set of "UVW" vertices on top of the wire frame "vertices" where our main object geometry "faces" meet / join / weld at "edges".
Reducing vertex count (plural for vertex is of course "vertices") helps run time performance in FS, so if a 3D model has walls and other exterior surfaces that are textured only on that exterior surface, we don't need the inner "face" surface to be exported in Sketchup.
For example, a hangar or other building that has no open surfaces and is textured on the exterior only (walls and roof) with no open doors that allow a view of the inside surface ...needs no 2nd surface when exported.
Thus, for a 3D model that needs no textures on the inside surfaces, we would not need / want to export 2-sided faces.
If one is using a wall or roof thickness created by 2 separate and non-co-planar surfaces, the inner "back" side of the textured faces will not be seen by the viewer, so if no other surface of the building will be textured on both sides of the same
single face, that would be a 3D model we'd export by disabling 2-sided faces.
The "savings" from not exporting un-needed vertices in static geometry would begin to add up so they could be "spent" elsewhere in the "vertex budget" for a complex aerodrome scenery, especially if there will be a performance hit from AI traffic etc., so its good to consider ones "Options" when exporting from Sketchup prior to import by MCX.
But, if one has an open door in a hangar or other building that allows the viewer to see inside, it requires us to texture both sides of each
visible face, or it would otherwise be transparent in FS; so for that kind of 3D model we
would want to allow 2-sided faces during export.
Hope these additional concepts might prove helpful !
Gotta' hit the road again....
[
EDITED]
PS: Looks like our posts crossed on the server.
Looking at the example 3D model in your screenies, the larger areas of the roof are made with 2-sided single faces, and the eaves of the roof are each a "box" type of object to use Jim's term, and so is your door and floor.
For the above example 3D model in your screenies, IMHO, one would
not want to
disable 2-sided faces during export of that 3D model from Sketchup, because the larger areas of the roof use 2-sided faces (the roof faces are textured on both sides).
It would be interesting to see what the results are if you were to export another copy of the 3D model in the latter screenies immediately above, but this time
do check the checkbox to "
Export 2-sided faces" (meaning do
not disable 2-sided faces on export).
[
END_EDIT]
GaryGB