• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Fresnel_ramp texture problem.

jtanabodee

jtanabodee

Resource contributor
Messages
3,924
Country
thailand
Hi,
I am a little bit confused with fresnel ramp texture. Do I need to have this texture in my local Texture folder of the airport I am making? Or just click on Fresnel Ramp in Material Setting to have effect to Diffuse, Reflection, Specular without having the Fresne_ramp.dds in my texture folder?
I did have a fresnel ramp in my texture folder. Then my model disappear. Just confused what is the best way to do.
 
I found that when I used fresnel ramp and applied to diffuse texture, the model disappeared.
 
I found what was the cause of missing ground poly.....
It is not Fresnel Ramp at all. There is a tunnel in my scenery which has been made by underlay afcad. It caused problem since it is near the center of ground poly. The ground poly is always at 0 elevation but the center of ground poly in that area sink below the ground cause by the tunnel elevation. My ground poly disappear under the ground.
 
You must log in or register to reply here.
Back
Top