• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSDS3.5 and boolean dificulty

L

luap

Messages
27
Country
us-wyoming
I am getting the message "part is not orientable" when I try to execute a boolean op to cut features.

using extrusions from templates I can cut the aileron, I can cut the trim tab into the aileron but when i try to use a template to make a rounded corner on the outboard tip of the leading edge I get this message.

I have tried to use a tool to cut the rounded corner with success but then when I go to cut the aileron I get the same message.

Any ideas?
 
I've had problems with the boolean operation in v3.5 as well. Unfortunately the error message I received was totally unhelpful, so I reverted to v3 to get a better idea of the problem and the cutout worked no problem, using the parts and tools prepared in v3.5! Re-opened the job in v3.5 and everything was fine with all the newly manufactured parts showing up and compiling as normal ?!?

What with a few other anomalies, I've now reverted to v3 to prepare the fsc in it's entirety, just using v3.5 for final compilation.
 
You must log in or register to reply here.
Back
Top