• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 Gmax Gear Animation Problem

Messages
292
Country
unitedkingdom
Hi all,

I am new to modelling & have a problem with the keyframe gear animation of the aircraft I am working on, I have keyframe animated the gear struts for rotation (retractable gear) & compression, but I have a problem animating the torque links which I am animating seperately, they need to be rotated when the gear goes from full extension to full compression, the top t-link is linked to the top strut which does not move when the gear is compressed & I have managed to animate this by rotating it anti-clockwise, however the lower t-link is linked to the bottom strut & moves when the gear is compressed so in order for both t-links to meet I need to rotate the lower t-link clockwise, but for some reason it will only rotate anti-clockwise. The pivot points for both t-links are in the same position on each object & are in local & not view mode.

I hope I have explained my problem clearly & any help will be most appreciated.

Paul
 

Attachments

  • L GEAR.JPG
    L GEAR.JPG
    54.3 KB · Views: 527
  • L GEAR 2.JPG
    L GEAR 2.JPG
    61 KB · Views: 490
Last edited:
Umm, well...are you trying to say that you can't rotate the lower bar during keyframe creation?
 
Yes, when trying to rotate the lower torque link using the keyframe animation control panel, it will only rotate anti-clockwise & I need it to rotate clockwise. I can animate the top torque link without any problems.

I am trying to animate it from keyframe 100-150 (0-100 is gear extension), I am starting with a rotation key at 100 & then another rotation key at 150, this works for the top torque link, I will have to do more torque link keyframe animations from 150-200 for the fully compressed gear.
 
Have you tried rotating the pivot point or switching to a linear controller?

This is quite unusual. I haven't run into anything like this so far.
 
I tried adjusting the pivot point, I don't know how to use linear controllers yet.

I managed to do it manually by moving the lower t-link while the animation button was on, but I would like to know why it will not work using the "Key Info" control panel.

Thank you for your help Heretic.
 
I managed to do it manually by moving the lower t-link while the animation button was on, but I would like to know why it will not work using the "Key Info" control panel.

Thank you for your help Heretic.

You're welcome.


Like Tom, I animate these things manually and hope no one will notice the very slight inconsistency.
 
Back
Top