Help with 3-way Switch

[wallydog69]

I'm attempting to create a 3 way spring back gauge switches between volts and amps and could sure use some help. Animation works fine but the needle is not responding correctly. Any thoughts, greatly appreciated.

Wally

    <PartInfo>
    <Name>volt_ammeter_switch</Name>
    <AnimLength>60</AnimLength>
    <Animation>
      <Parameter>
        <Code>30 (L:VAmp, bool) 30 * + </Code>
        <Lag>100</Lag>
      </Parameter>
    </Animation>
    <MouseRect>
      <Cursor>hand</Cursor>
      <MouseFlags>LeftSingle+RightSingle+WheelUp+WheelDown+LeftRelease+RightRelease</MouseFlags>
      <CallbackCode>
        (M:Event) 'RightSingle' scmp 0 == if{ 1 (>L:VAmp, bool) }
        (M:Event) 'LeftSingle' scmp 0 == if{ -1 (>L:VAmp, bool) }
        (M:Event) 'RightRelease' scmp 0 ==
        (M:Event) 'LeftRelease' scmp 0 == or
        if{ 0 (>L:VAmp, bool) }
      </CallbackCode>
    </MouseRect>
  </PartInfo>


  <PartInfo>
    <Name>volt_ammeter_needle</Name>
    <AnimLength>100</AnimLength>
    <Animation>
      <Parameter>
        <Code>(L:VAmp, bool) 1 == if{ (A:ELECTRICAL MAIN BUS VOLTAGE, volts) 5 * } els{ (L:VAmp, bool) -1 == if{ (A:ELECTRICAL GENALT BUS VOLTAGE:1, volts) 5 * } els{ (A:ELECTRICAL GENALT BUS AMPS:1, amperes) 1.25 * }}</Code>
        <Lag>100</Lag>
      </Parameter>
    </Animation>
  </PartInfo>

 

[spokes2112]

try changing all your L: variable types from "bool" to "number" - other than that it looks good. (too early in A.M. though )

 

[wallydog69]

Thanks Roman.. found the bugger..one of the brackets was a parenthesis