- Messages
- 10,163
- Country

Hey all,
First. I am a detail freak. One of the things I discovered I could do is make tiny screw heads and fasteners that are high detail and paste them (mapped) onto tiny squares (Polygons) and hover them over the plane's mesh and place them where screws and fasteners exist.
I then have brilliant detailed small items on the planes exterior that when doing a zoom in, you see them in full detail. I have a blacked edge around the round objects graphics, and with an adjusted Alpha, they appear round in FS.
One thing that always plagues me is 'adjusting them' one at a time, on one side of the fuselage, perhaps 50 or more of these things. Once done, I simply clone, mirror and move to the opposite side of the fuselage (or wing). But the first time takes a LONG time to do each single Polygon.
So today, I decided to look up Align. I had heard many people talk about it, but never figured it out. I found that there are two Align tools on the top toolbar and found that the first 'Align' was quite difficult. But..... The 'Normal Align' was brilliantly simple!
1. Simply have the part selected that must be aligned with said fuselage
2. Click on the Normal Align
3. Click on the center of the Polygon with the cross hairs 3 times
4. The part then appears to be located in the surface of the fuselage but reversed as you are matching the Normals (Polygons) to each others face.
5. Click Reverse Normal and this flips it back outwards again
6. When done with a row, simply click on them and gently move them outwards of the fuselage a very slight amount so that no 'flickering' of intermixed surfaces occur.
A picture (to me) is worth a thousand words, so Voila!
Than the Lord for such an awesome find.
Bill
First. I am a detail freak. One of the things I discovered I could do is make tiny screw heads and fasteners that are high detail and paste them (mapped) onto tiny squares (Polygons) and hover them over the plane's mesh and place them where screws and fasteners exist.
I then have brilliant detailed small items on the planes exterior that when doing a zoom in, you see them in full detail. I have a blacked edge around the round objects graphics, and with an adjusted Alpha, they appear round in FS.
One thing that always plagues me is 'adjusting them' one at a time, on one side of the fuselage, perhaps 50 or more of these things. Once done, I simply clone, mirror and move to the opposite side of the fuselage (or wing). But the first time takes a LONG time to do each single Polygon.
So today, I decided to look up Align. I had heard many people talk about it, but never figured it out. I found that there are two Align tools on the top toolbar and found that the first 'Align' was quite difficult. But..... The 'Normal Align' was brilliantly simple!
1. Simply have the part selected that must be aligned with said fuselage
2. Click on the Normal Align
3. Click on the center of the Polygon with the cross hairs 3 times
4. The part then appears to be located in the surface of the fuselage but reversed as you are matching the Normals (Polygons) to each others face.
5. Click Reverse Normal and this flips it back outwards again
6. When done with a row, simply click on them and gently move them outwards of the fuselage a very slight amount so that no 'flickering' of intermixed surfaces occur.
A picture (to me) is worth a thousand words, so Voila!
Than the Lord for such an awesome find.
Bill
Last edited:
