• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Loading Issue with Pro Key

J

jetpilot1980

Messages
107
Country
us-virginia
Hello,

So last week I had a small brownout at my house after a thunderstorm... The result was brutal and my Windows was wiped after going into the boot repair mode and the mysterious x: drive.... Anyway I was able start re-building my PC by cloning off my backup hard drive... With ways to go... I had an old copy of ADE 1.67 installed and tried to reinstall ADE 1.78 with my pro-key. While ADE 1.67 runs fine and I keep getting the following message from ADE 1.78 when I try to start the program:

ADE prokey issue.JPG


What I have tried:

1. Installed 1.78 fresh and used a pro-key.zip download

2. Deleted 1.78 then reinstalled 1.78 and had it import the pro-key from the 1.67 install this worked for the initial start up where I did the import; but once I closed the program and tried to restart it I got the same message again. But 1.67 continues to work fine with a prokey.

Any ideas as to what could be causing this?

Thanks
 
You must log in or register to reply here.
Back
Top