• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

My GMax Has Gone Wierd

B

BrBlazer

Messages
481
Hi again,

GMAX is giving me a hard time today. Everything was fine until gmax crashed and saved a recover copy. When I reopned, and chose the "Select and Move" tool, I can no longer see the Y, X and Z's with the arrows so I could manipulate only one of them. The Y, X and Z's are there, but no arrows and whatever I move, it moves to all sides since there is no arrow to only move in one direction. What's up with that? I hope I made myself clear as I cannot understand it myself lol

Thanks again :-)
 
Do you have this problem if you start a new scene, or only when opening the crash recovered file?

Lou
 
Hi,

Everywhere. I didn't actually use the recovered file since I had saved the real file before doing what I did that crashed.
 
Hi. I found a fix. Looking at an old gmax.ini file I saw a diffence in the line bellow:

TransformGizmo=1

The current gmax.ini had the value 0, therefore I changed it to one and it worked ok like before. I'm sure theres an option inside gmax to change this, I just don't know where.
 
You must log in or register to reply here.
Back
Top