• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 problem with fs

Messages
4
Country
unitedkingdom
Does anyone have any suggestions what this could causeing this?.
The problem start with FS2004 on my laptop
At first it was alright(fs2004 flew concorde from london to new york and it was ok ) and now I have this problem.
Problem:
A few minute after take-off, the problem start when you put the auto pilot on.
(Autopilot has been set by reading a tutorial).
After put the auto pilot on the aircraft start lose speed then stall and then lose altitude.
Then you find yourself going along the ground with no way off get back up in the air
(Even try to take-off manual it will not go up).
I have now got FSX deluxe edition same thing happens.
I have bought a new dasktop pc with FSX and FS2004 on it and I stall have the same problem.
 
Sometimes aircraft will stall if the auto pilot is set at too 'steep' of an angle and your airspeed isn't high enough. The sharp angle causes you to lose speed until you lose lift and fall.

You must reduce your angle to keep your speed up.


You should never take off with auto pilot. That is usually always done manually.


I should also tell you that this is mostly a forum for airplane and airport makers, not so much about flying. Some of us are always willing to help out though.

Autopilots are not always tuned to airplanes and should be closely managed. They are not perfect systems, either in real world or the sim world. ;)



Kind regards,

Bill
 
Back
Top