• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

RAM Problems

Messages
1,269
Country
us-northcarolina
Hey guys! I know this isn't exactly a hardware forum, but I trust y'all over folks I don't know (as well) :p

Anyhow, the story goes...I was doing a new computer build, got everything installed and it's running like a beauty. However, I have one small problem. I have 2 sticks of 8GB DDR3 installed, but even though W7 is recognizing the full amount, it's only using half of it.

Quite irritating to spend all this money and not have it work...

Any suggestions?
 

Attachments

  • Untitled.png
    Untitled.png
    3.7 KB · Views: 495
Last edited:
Try running resmon to see what it reports on memory usage. Click the Start buton then type resmon in Search Programs and Files
 
I suppose you could also try running with one stick at a time in one or the other slot to make sure everything is working.

Bob
 
Which slots do you have the RAM installed to?

They need to be in 1+3 or 2+4 slots when using pairs. Another words, always skip a slot with your pairs.

Good luck and hope you enjoy the new build!
 
Results of resmon below. Could the OS or BIOS be reserving 8GB as an "overflow" from the GPU?

Edit: As a side note, I have the sticks in slots 2 & 3 rather than 1 & 2 just because there was much more space to put it in since I have the thick hose coming from the radiator right next to slot 1. Could this be an issue?
 

Attachments

  • resmon.png
    resmon.png
    9.7 KB · Views: 458
Last edited:
Have you check the motherboard and the slots max. capacity? I guess yes.:duck:
It's said the sticks must be placed in this way: 1+3;2+4 and check the bios too, I can't remember but maybe you have to update something there
 
Last edited:
Have you check the motherboard and the slots max. capacity? I guess yes.:duck:
It's said the sticks must be placed in this way: 1+3;2+4 and check the bios too, I can't remember but maybe you have to update something there

I'll try 2+4 and see how it comes out!
 
Awwwwww yeahhhhhh! Who knew something so simple could cause that? Thanks guys :D
 

Attachments

  • 2.png
    2.png
    67.7 KB · Views: 513
Back
Top