- Messages
- 14
- Country

Hello, I wonder if you can make a recess (hole) in a created polygon?
Regards, Jaap Mooijer
Regards, Jaap Mooijer
Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.
By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.





Given the OP's posting history thus far, I'd agree with George on this being more likely.Is he not talking about ADE polygons?



>

Why is this in the "General Discussion" and not in the "Modeling" section?

Beware the forum police! He's correct and you should post in the modelling section. The answer is yes you can make a recessed hole in a polygon. Study your modelling software, this is a very basic operation.

See Post#6 "Moved thread"Brother, we are in the Modeling section LOL.![]()
