- Messages
- 502
- Country

Hi Folks,
[FS9]
I'm coming from modeling in MSTS - where we had very specific rules for LOD's... You had to keep the number of groups the same - if the primary model had a a group that used two texture sheets - all the LOD models had to have at least one textured part from each sheet - and - it really had to be put together in the modeling software... It was kind of a pain...
Now for MSFS - I'm just exporting my models via Direct-X and using "makeMDL" to create the model... I'm not using GMAX or FSDS...
I noticed the LOD screen on "makeMDL" so real quick and dirty - what's the basic process ??? Make several models - and - use the LOD tab in "makeMDL" to create the LOD's ??? Are there any specific rules or interdependencies for LOD's ??? How do I specify the distance that each model will be visible ??? Is there a naming convention that needs to be adhered to ??? Any other LOD tips most welcome...
Regards,
Scott
[FS9]
I'm coming from modeling in MSTS - where we had very specific rules for LOD's... You had to keep the number of groups the same - if the primary model had a a group that used two texture sheets - all the LOD models had to have at least one textured part from each sheet - and - it really had to be put together in the modeling software... It was kind of a pain...
Now for MSFS - I'm just exporting my models via Direct-X and using "makeMDL" to create the model... I'm not using GMAX or FSDS...
I noticed the LOD screen on "makeMDL" so real quick and dirty - what's the basic process ??? Make several models - and - use the LOD tab in "makeMDL" to create the LOD's ??? Are there any specific rules or interdependencies for LOD's ??? How do I specify the distance that each model will be visible ??? Is there a naming convention that needs to be adhered to ??? Any other LOD tips most welcome...
Regards,
Scott
Last edited:
