• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Rules for LOD's ???

Messages
502
Country
unitedstates
Hi Folks,

[FS9]

I'm coming from modeling in MSTS - where we had very specific rules for LOD's... You had to keep the number of groups the same - if the primary model had a a group that used two texture sheets - all the LOD models had to have at least one textured part from each sheet - and - it really had to be put together in the modeling software... It was kind of a pain...

Now for MSFS - I'm just exporting my models via Direct-X and using "makeMDL" to create the model... I'm not using GMAX or FSDS...

I noticed the LOD screen on "makeMDL" so real quick and dirty - what's the basic process ??? Make several models - and - use the LOD tab in "makeMDL" to create the LOD's ??? Are there any specific rules or interdependencies for LOD's ??? How do I specify the distance that each model will be visible ??? Is there a naming convention that needs to be adhered to ??? Any other LOD tips most welcome...

Regards,
Scott
 
Last edited:
Hi Scott,

The easiest way to add lods is to name your parts with the right name. The convention is _LOD_xxx. Where xxx is the number of the lod. Often used values are 10, 40 and 100. You can then have all your lods in one x file.

There are no rules for amount of parts or textures per lod.

Send from my phone using Tapatalk, so excuse the short sentences and possible typos
 
Back
Top