• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX Runtime error R6025 in FSX acceleration

C

Chris75

Messages
17
Country
unitedkingdom
Hi,

I have been flight simming for about 40 yrs and have never come across this problem before.

Namely: R6025 Pure Virtual Function Call

This then gives me a window to click on OK and the fsx acceleration sim crashes to desk top.

I am baffled. I have been dabbling with repainting certain aircraft and have gone over each one checking if I have left a .bmp file where it shud be a .dds etc
but have found none.
I have checked all the changed aircraft config files in case of mistakes but have found none.
I have loaded up new paints and aircraft but they were all bonifeide sites.
can anyone point to something here? it's annoying as it's halfway through flights or at the beginning or even when in slew mode viewing AI aircraft.

I have 32 gb ram
a very fast amd 4.5 ghz processor and board to match
and a very good psu to cope with it all.
also I get about 100 fps with all this.

I do have a feeling it's something I've done recently as it's only been happening in the past maybe 2 weeks.

maybe I should just remove each and every add on and repaint, one at a time, to see what is causing this, but that is a mammoth job as I tend to do things in large batches.

Your help is much appreciated in advance,

Thank you
Chris
 
Well in absence of expert advice (ahem!) I used my FSXA disc and did a repair of FSXA due to another problem and so far I have not come across the run time error.
The repair fixed a start up problem funnily enough. I had been "y-ing" slewing for ages and when I went to "real" flight I coudln't get me DC3 engines started. all fixed I hope.
cj
 
You must log in or register to reply here.
Back
Top