- Messages
- 2
- Country

Hello all,
I'm trying to create the effect of a rotating propeller to simulate propeller movement prior to combustion during the start sequence. As you'll be aware, Flight simulator turboprop propellers don't turn until combustion starts.
On the Tyne engine during start, the engine accellerates to a very low rpm, to avoid overheating, a state known as Low Ground Idle. Once demander, the fuel flow is progressivelly increased until High Ground Idle is reached.
I have programmed a dummy propeller to rotate as desired during the low ground idle stage, and this works fine. My problem is that I want the dummy prop to become invisible on combustion in the sim takes place and the real prop begins to rotate.
I've tried all sorts of combinations with visibility tags and getting nowhere.
The current setup, which has the prop rotating is thus:
The (L:No1_LGI,number) controls the prop rotation and repeatedly counts from 0 through 100, Id like the part to be invisible if the (L:No1_LGI,number) is greater than 110.
<part>
<name>SCREW_PORT_OUTER</name>
<visible_in_range>
<animation>
<parameter>
<code>(L:No1_LGI,number)</code>
<lag>200</lag>
</parameter>
</animation>
<maxvalue>110</maxvalue>
</visible_in_range>
</part>
Additionally I need to find a way to make the real propeller invisible when there is no combustion
Thanks in advance,
Fraser
I'm trying to create the effect of a rotating propeller to simulate propeller movement prior to combustion during the start sequence. As you'll be aware, Flight simulator turboprop propellers don't turn until combustion starts.
On the Tyne engine during start, the engine accellerates to a very low rpm, to avoid overheating, a state known as Low Ground Idle. Once demander, the fuel flow is progressivelly increased until High Ground Idle is reached.
I have programmed a dummy propeller to rotate as desired during the low ground idle stage, and this works fine. My problem is that I want the dummy prop to become invisible on combustion in the sim takes place and the real prop begins to rotate.
I've tried all sorts of combinations with visibility tags and getting nowhere.
The current setup, which has the prop rotating is thus:
The (L:No1_LGI,number) controls the prop rotation and repeatedly counts from 0 through 100, Id like the part to be invisible if the (L:No1_LGI,number) is greater than 110.
<part>
<name>SCREW_PORT_OUTER</name>
<visible_in_range>
<animation>
<parameter>
<code>(L:No1_LGI,number)</code>
<lag>200</lag>
</parameter>
</animation>
<maxvalue>110</maxvalue>
</visible_in_range>
</part>
Additionally I need to find a way to make the real propeller invisible when there is no combustion
Thanks in advance,
Fraser
