• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FS2004 Secondary tower frequencies not always active

TheRedBadger

TheRedBadger

Messages
102
Hi y'all,

Was wondering why sometimes extra tower frequencies at an airport however listed are not active? I annoyingly noticed at MCO when the same tower was speaking to both the West and East side on a pretty busy day. Same with LAX. I checked with ADE to see if the frequencies are properly labeled (airport name, no frequency outside the 118-135ish range) with the same going on.

This wasn't a problem with the O'Hare scenery I created sometime ago. (I would float in slew mode and I would notice the frequencies to contact would change as I move North to South).

Thanks!
 
You must log in or register to reply here.
Back
Top