• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

FSX Seriously Screwed Normals!

n4gix

Resource contributor
Messages
11,674
Country
unitedstates
Well, this is a new one for me...

I've been working on Richie's Global Express XRS trying to add some "bling," and I've encountered real puzzler...

Check the image below and see how the normals are not perpendicular to the surface at all, but are at some severe oblique angles. Worse, where they suddenly switch directions, it causes some really NASTY shading issues in the sim...

Not shown in this picture are the three spoilers, two of which have "rear sloping normals" whereas the inboard spoiler has "forward sloping normals..."

Anyone have any ideas on how to fix? :yikes:

screwednormals01.jpg

Shot at 2009-10-19
 
I want to think that you have co-located vertices, and that the polygons are not connected to each other.

You may have "folded" polygons?
 
Back
Top