• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

P3D v1 Setup of animations

Messages
10,163
Country
us-arizona
Hey all,

I animate a landing gear and usually it will go properly from point A to point B to point C. On this one, rescaled and reset on its X-Form before animating, it gets near point B and goes way past its animation (a curve upwards) and then back to point B. Same to point C.

Driving me crazy!!!!!!!!!!!!!!!!!!

I have to put in 10 different fix points to keep it from jumping up as it keeps redoing its jump curves when I edit them out with new fix points.

I remember hearing 'somewhere' that we should set 'something' in Gmax/Max to 'something' for use in the FSX SDK.

Does anyone know what I am talking about and can anyone shed some light on this issue/phenomenon/mystery and is there a way out of this?

<--- using Max 2012, which is fairly close to Gmax.


Bill
 
Awesome...

Thanks Tom and Zeiten.

Ive never had 'tooooo' many issues with this before, but this time, its CRAZY! It has finally come time for me to figure out what this setting was and where it is.
 
It is so easy to do this mistake.

You work in the interior (and of course the controller is set to linear)
Then you start a new scene for the exterior and animations starts to take shape then all of a sudden this happens because you got used to not think about it working on the interior.

One thing to do is setting linear to default.
Then every scene you start up with have linear control.

Motion->Parameters->Then the little box with the "?" symbol on it.
Then just select linear and press make default.
 
Last edited:
Back
Top