• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Slice Plane Tip

Messages
10,163
Country
us-arizona
Hey all,

I have made a little discovery. WHen I used to use Slice Plane, using 'Cut' on Polygons, I would have a ton of extra, left over Vertices. Horrible, so I stopped using it. But, yesterday I was experimenting with this and found that I could cut a 'Editable Poly' object much better then Editable Mesh. (I think that Polys do not use triangles, but Mesh objects do, so you get the extra Vertices).

So, I found that it cuts in both Polygon and Edge modes nicely. However, in Edges mode, it automatically cuts through all Edges 'no matter what', where as in Polygon mode, you have to select the Polygons to cut.

Next is, you must use 'Slice' when using the Slice Plane.


Thats it! Works brillant. Just cut a landing light bucket out of a leading edge of a wing in record time. I love record time work. :)




Bill
 
I prefer doing just about everything in EPoly mode.

Too bad though that GMax' implementation of it is rather...lackluster (can't add a modifier to the stack).
 
I prefer doing just about everything in EPoly mode.

Too bad though that GMax' implementation of it is rather...lackluster (can't add a modifier to the stack).

Horsefeathers! A ring of polys on this sphere has been selected and the Slice modifier used to remove the upper section of these polys above the Slice Plane. Or are you just missing the Edit Poly modifier from Max?

epolyslice.jpg




Like Bill says, this way the vertex count does not appear to go through the roof: cheers Bill!
 
Last edited:
Back
Top