• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Tip For Decal Freaks

Messages
10,163
Country
us-arizona
Hey all,

If you are a fellow decal freak and you love your placcards and decals to be readable, like the fuel decals next to the fuel caps, 'No Push' decals on the wings, etc, try this. Create the texture on a texture sheet first (graphics), then make a polygon that fits that shape and map the graphics of the decal onto the Polygon sheet. Float that over the area that it goes to. This works great for prop decals as well. Flaps have that 'No Push' on them. Hover it over the surface and link it to the flaps. Now, when people repaint your planes, your decals remain undaunted and with extreme resolution.

The same with panel labels over switches. Just create all your labels on a graphics sheet and map them to rectangle polygons and float them over your panel. You may have to move them out a bit if they 'flash' when in the sim. Adjust and recompile if they do.

One of my trade secrets is I also do this with screws (before bump mapping days). I can have removeable screw zirk fittings along a cowling edge, using floating square polygons with the screw head mapped to it, and a pure black (with adjusted pure black Alpha) on the sides of the screw head, and all you see is the nice little round object, and not the entire 'square' shape.

Really is nice for closeups...



Bill
 
Welcome to the world of decals, Bill!


Been using "decaled" panel lines and rivets for the top and bottom of the fuselage for a long time, all to keep the fuselage texture intact and thus easily repaintable.

I've tried to get bump mapping to work on those decals without success yet though, but I think I just didn't try hard enough.
 
From Makemdl SDK:
If the texture name starts with “DECAL_” a z-bias is added automatically to all polygons drawn with this texture.

or material name prefix "ZBIAS_##" (##=0..15) to avoid 'flashes'.
;)
 
From Makemdl SDK:


or material name prefix "ZBIAS_##" (##=0..15) to avoid 'flashes'.
;)

I think that only applies to FS9 in FSX you can name decals anything you want, it's just a case of putting the right settings in the material editor.
 
Thanks for this tip!
Should make for some nice decals/placards!

I'll sure be using this method in the future.

grt
Willem
 
Back
Top